Turner Industries

This listing is for Paint Sandblaster positions at our Fabrication Shop in Paris, TX.

Please apply in person at any Texas Workforce Solutions location near you:

5210 SE Loop 286, Paris, Texas

1513 Houston Street, Sulphur Springs, Texas

1205B E. Sam Rayburn Drive, Bonham, Texas

2415 S. Austin Avenue STE 105, Denison, Texas

Job does not pay per diem

Job Description:

Directs blasts of abrasive-laden compressed air from nozzle against metal or hard composition objects to remove adhering scale, sand, paint, grease, tar, rust and dirt and to impart an even finish.

Functional Requirements:

Moves controls to adjust pressure and concentration of grit to obtain specified finish; wears gloves and helmet, or hood, to protect against breathing sand-laden air and injury to eyes and hands; may mask areas not being sandblasted; may order materials as needed.

Qualification Standards:

• Minimum two (2) years of experience required.
• Written pre-employment qualification test.
• Post-offer drug/alcohol screen and physical evaluation
• Hazard Communication orientation/test
• Turner industries Group, LLC Indoctrination
• OSHA approved corrective eye wear (Z87)
• Job site orientation
• Job site safety requirements as required by the client (clean shaven, long sleeves, steel toe boots, etc.)
• Safety equipment as required by the client (hard hat, safety glasses, gloves, respirator, hearing protection, safety harness with lanyard, etc.)
• Applicant/employee must not pose a direct threat to the health or safety of such individual or others in the work place.

Physical Involvement

Employee may be required to do the following: climbing ladders, scaffolds, structures, etc. above and below ground level; maintaining balance on ladders, scaffolds, structures, etc.; reaching in all directions, handling and manipulating objects and materials; coordinating the movements of eyes, hands and fingers to operate tools and equipment; lifting 30 to 50 pounds from ground level, waist level, and/or overhead; carrying objects, tools equipment, etc.; standing; sitting; walking; pushing; pulling; bending; kneeling; crouching/squatting; crawling; seeing with or without correction; hearing with or without correction.

Mental Involvement:

Employee may be required to do the following: following set procedures and standards; applying basic mathematical skills; repeating tasks of short duration according to a set procedure; planning work and selecting proper tools; following oral and/or written directions; reading; writing; ability to recognize and report safety hazards.

Work Environment Factors:

• Location: industrial construction sites and/or fabrication shop
• Mobility Barriers to Access Job Site: uneven ground level; obstructed pathways; work performed at low and/or high elevations; work performed in confined areas.
• Climatic/Environmental Conditions at Job Site: predominately outdoor climate; may be exposed to extreme hot or cold weather, excessive humidity, rain, etc.; various noise levels caused by tools, machinery, equipment, etc.; potential exposure to chemical substances.

Turner Industries is an equal employment opportunity employer. All qualified individuals will receive consideration for employment without regard to race, color, age, religion, sex, sexual orientation, national origin, disability and/or protected veteran status in accordance with governing law.